SL-ED100T1 Lightgate M2 Lighting equipment controller, 2xXLR-3F, Siberian Lighting

Description:

SL-ED100T1 Lightgate M2 Lighting equipment controller, 2xXLR-3F, Siberian Lighting

The LightGate M2 is designed to control DMX lights and SPI LED pixels over an Ethernet local area network (ArtNet).
Two bi-directional DMX ports.
Built-in dual port 100Mb Ethernet switch.
Supports ArtNet v4 protocol, DMX512, DMX1024HS, SPI (pixels), RDM* (*firmware release pending).

Compatible with any software and console that supports the ArtNet network protocol.
The built-in two-port Ethernet switch allows to connect several controllers one after another, or connect two ArtNet sources (remote controls) to one controller without additional devices.
Any DMX port can be switched to input mode, which allows you to connect a fader panel ("DMX comb") and control the lighting program parameters using physical faders, or transmit the values of the channels of a physical DMX signal to the renderer via ArtNet.
The DMX port in output mode allows you to connect DMX lights (Spot, Wash, Par, etc.) whose total number of control channels does not exceed 512 per port, or 1024 channels per two DMX ports.
The port in SPI mode allows to connect LED pixels such as WS2811, WS2812, WS2818, UCS1903, TM1803, TM1914 and others with a single-wire data line. It is possible to select a preset pixel type preset, or manually set the parameters of the SPI signal (Period from 1 to 2.5 us; T0H from 0.1 to 2.4 us; T1H from 0.2 to 2.4 us; RES from 10 to 500 us, including support for Low and High speed, support for switching color order).
Supports up to 680 RGB pixels (corresponding to 2048 channels / 4 universe ArtNet) SPI pixel line length per output port. In total, the device can drive up to 1360 RGB pixels (corresponding to 4096 channels / 8 universe ArtNet). Physically, the SPI output signal is symmetrical, which will allow using RX-BOARD to transmit a signal to 100-300 meters. Without the use of RX-BOARD up to 3-10 meters.

Device specifications:
- 2 bi-directional DMX ports
-up to 9 universe ArtNet 4
- Metal housing, IP30
- Support for ArtNet v4, DMX512, DMX1024HS, SPI (pixels), RDM* protocols (*firmware release pending)
- Support for setting DMX512 timings
- Galvanic isolation of each individual DMX output by power and optical by signal
- High voltage protection for all DMX ports
- Electrostatic protection of all DMX ports
- Firmware support for LightingOS-G
- DMX Connectors: 2x Neutrik XLR 3pin (F)
- Dimensions (LxWxH): 114.2x88.5x42 mm
- Net weight: 400gr.

In a box: - LightGate M2 device
- Ethernet cable (patch cord) 1.5m
- Power supply (Euro plug, input 100-240 VAC 50/60 Hz, output 5VDC 2A, connector 5.5x2.5)