SL-EDEC91F3W LANUNO XLR-3F WiDMX Rev2.1 Lighting equipment controller, Siberian Lighting

Description:

SL-EDEC91F3W LANUNO XLR-3F WiDMX Rev2.1 Lighting equipment controller, Siberian Lighting

The LanUNO 512 controller is designed to control DMX lighting fixtures and controllable LED pixels via an Ethernet local area network. Supports ArtNet v3 protocol, DMX512, pixel SPI. The controller has one bi-directional DMX port.

WiDMX transceiver operates at a frequency of 2.402 - 2.480GHz, ISM, 79 channels; 20dBm; FHSS; GFSK Radio transmission distance up to 600m line of sight; Antenna 2dBi external, SMA connection connector "plug", the ability to connect a more powerful antenna to enhance signal transmission.
Operating modes: transmitter, receiver, disabled.
Separate ArtNet Universe for WIDMX transceiver.
Compatible with worldwide radio protocol standards:
WIDMX Protocol
W-DMX Receive Protocol
W-DMX G3 Transmit Protocol
Guangzhou (GZ) Protocol) (as a rule, all Aliexpress devices work only on this simple protocol).
WiDMX-01F (SL-WD01F) can be used as a compatible WiDMX receiver, or WiDMX-01M (SL-WD01M) can be used as a transmitter.

Compatible with any software and console that supports sending/receiving ArtNet packets.
The DMX port in LED pixel control (SPI) mode allows you to connect up to 680 pixels of WS2811, WS2812, WS2812b, WS2818, TM1804, TM1903, TM1803 and other timing-compatible protocols. The SPI output is balanced, which allows the SPI signal to be transmitted up to 300 meters without amplifiers.
The RX-BOARD board can be used as a balanced SPI to unbalanced converter.
The DMX port in input mode allows you to connect a fader panel ("DMX comb") and control the lighting program parameters using physical faders, or transmit the values of the channels of a physical DMX signal to the renderer via ArtNet. The DMX port in output mode allows you to connect DMX lighting fixtures (Spot, Wash, Par, etc.) with a total number of control channels that do not exceed 512.
The Standby Scene function allows you to launch 1 static scene from the controller's internal memory without using an ArtNet source using a button on the front panel of the device or by sending ArtNet macros using the DMXWorkshop utility. Recording of the "Standby Scene" is also done by pressing a button or by an ArtNet macro. In this case, the static values of the DMX channels at the DMX output ports are written to memory.

Device specifications:
One bi-directional DMX port
1 universe ArtNet 3 and up to 4 universe ArtNet 3 in SPI mode
Galvanic isolation of Ethernet and DMX
Electrostatic protection of the DMX port
Customizable IP address
DMX Connectors: 1x Neutrik XLR 3pin (F)
Dimensions (LxWxH): 86.8x57.2x42 mm
Net weight: 300 gr.
Packaging (LxWxH): 225x173x63 mm.
Gross weight: 550 gr.

In a box:
Device LanUNO 512
Ethernet cable (patch cord) 1.5m
Power supply (Euro plug, input 100-240 VAC 50/60 Hz, output 5VDC 2A, connector 5.5x2.5)